基于北斗卫星通信定位的战斗机队形指挥控制系统设计

Design of Fighter Formation Command and Control System Based on Beidou Satellite Communication Positioning

摘要:

目前设计的战斗机队形指挥控制系统数据匹配度低，指挥性能较差。为了解决上述问题，基于北斗卫星通信定位设计了一种新的战斗机队形指挥控制系统，对系统的硬件和软件进行优化设计。硬件。主要由定位器、指挥器、信号接收器和监控器组成，选用HD-38型号的定位器，提高定位精度，采用HD-72X型号的指挥器，增强系统的整体指挥模式，同时在信号接收器上设置单频、双频、三频三个模式，利用UPS续航电源对系统进行供电，从而提高系统的储电能力。通过控制战斗机的队形变换、队形保持以及队形控制来完成战斗机队形指挥控制。实验结果表明，基于北斗卫星通信定位的战斗机队形指挥控制系统能够有效提高系统的数据匹配度，提升战斗机队形指挥控制效率，增强指挥性能。

Abstract:

The currently designed fighter formation command and control system has low data matching and poor command performance. In order to solve the above-mentioned problems, a new fighter formation command and control system was designed based on Beidou satellite communication and positioning, and the hardware and software of the system were optimized. hardware. It is mainly composed of a locator, a pilot, a signal receiver and a monitor. The HD-38 type locator is selected to improve the positioning accuracy. The HD-72X type pilot is used to enhance the overall command mode of the system. At the same time, the signal receiver three modes of single-frequency, dual-frequency, and three-frequency are set up on the device, and the UPS endurance power supply is used to supply power to the system, thereby improving the power storage capacity of the system. The command and control of the fighter formation is completed by controlling the formation transformation, formation maintenance and formation control of the fighters. Experimental results show that the fighter formation command and control system based on Beidou satellite communication positioning can effectively improve the data matching of the system, enhance the efficiency of fighter formation command and control, and enhance the command performance.