红外碳硫传感器信噪比改善方法研究

SNR Improvement of Infrared Carbon and Sulfur Sensor Method 

摘要:

应用于钢铁、矿物等检测的红外碳硫仪的研制在国内的研究还存在诸多问题,由于其在红外检测中位于一个非常敏感的区域,国内高精度红外碳硫传感器的研究迫切需要迈上新台阶;其检出限和检测精度要达到国际先进水平还存在传感器的气室工艺不够、探测器与光源的资源限制、信号的调制方式落后等问题;当然也存在信号的前期滤波、信号后期处理方面的原因;文章针对当前红外碳硫传感器的研究现状,对改善信噪比的方法进行探究和分析,并提出了相应的解决措施和具体思路。

Abstract:

In domestic research of infrared carbon and sulfur analyzer are still many problems, because it is located in a very sensitive area in the infrared detector, the researchers domestic high-precision infrared carbon and sulfur sensor is an urgent need to a new level. The detection limit and detection accuracy to reach the international advanced level there is not enough of the sensor chamber technology, resource constraints detector and light source modulation signal behind other issues. Pre-filtered reason, the signal post-processing of the signals, of course, also exist. In this paper, current research status of infrared carbon and sulfur sensors, improving the signal to noise ratio method to explore and analyzed, and the corresponding solutions and concrete ideas.